CBHF2 - High Frequency 48V Battery Charger
Technical Features
• High frequency system with advanced technology.
• Charging process fully controlled by microprocessor.
• Efficiency > 90%.
• Insensitive charge parameters related to input line
voltage variations
• Visualization on a lit display of the charging current, of
the battery voltage, of the charging time, of the charge
supplied in Ah and of the energy absorbed in KWh.
• Possibility to change the charging curve by means
of buttons (LCD version), choosing from 16 standard
pre-programmed curves for lead-acid, Gel and AGM
batteries. Any other curve available on request for all
type of batteries (Li-lon and Li-Po included).
• dV/dt adaptive charging profile available under request
for Wet lead-acid traction batteries.
• Possibility to change the battery voltage and the charging
current by means of buttons (LCD version).
• Charging process starting in the “soft start” mode and
automatic reset upon connection of a new battery.
• Alphanumeric signals of possible anomalies.
• Output ripple at maximum load lower than 100mV.
• Compensation of the voltage drop on the connecting
cables to the battery.
• Charge cycle begins with batteries as low as 2V.• Protection against polarity inversions, short circuits,
over-voltages or anomalies.
• Thermal protection against overheating.
• Equipped with NC (normally closed) relay for safety
interlock connections (available only for on-board
installation).
• Operating temperature:
-10°C ÷ +45°C (14°F ÷ 113°F).
• Maximum relative humidity: 90%.
• International Protection Rating IP30 with
forced ventilation.
• Self-extinguishing case made of UL94-VO ABS.
• Remote 3-LED (red,yellow and green)
of recharge (optional) with
• 3-LED board (code: SKLED)
• 3-LED 18mm diameter round remote indicator
(code: LBF318EZ)
• 3-LED 22x30mm squared remote indicator
(code: LBF3QEZ)Dimensions
Length - 180mm
Width - 310mm
Height - 100mm